Concria™ Plastic Floating Pans remain today the finisher’s choice when the
high FF Numbers (Floor Flatness) are specified on concrete floors and when
an aesthetic uniform surface is needed. Plastic pans are attached to standard
steel pans easily and fast with a patented velcro fastener system.

✔ Smoother and uniformly finished surface

Plastic pans bring fewer aggregates on top while floating and minimize aggregate popouts and reduce the chance of surface delamination. Plastic pans eliminate the risk of leaving burn marks and create a more uniform color surface than steel pans.

✔ Denser slab with acoustic pressure

Concria™ Plastic float pans have an acoustic impedance (ratio of the acoustic pressure) that matches the concrete, thereby imparting its energy into the concrete mass, which causes the concrete to set from the bottom of the slab to the top while maintaining an open surface to allow bleed water to escape during finishing.

Steel pans dig deeper than plastic pans and move more surface mortar/cream, making the floor less flat. With plastic float pans, you also minimize the risk of troughing better than with steel pans if the concrete is too soft or if you hit a wet spot. Plastic provides an easier transition from wet to dry areas when floating.

✔ Faster Finishing time

Concria™ Plastic float pans provide a faster finish time as plastic doesn’t dig deep as steel, and you can start a little bit earlier with plastic pans.